ABB RMC-100 User Manual page 120

2. Connect to the device's MMI or USB port.
Launch PCCU and click Entry on the toolbar. The navigation tree displays.
3.
Click Communications. Then click Network.
4.
5. Select SSH/SFTP service.
Figure 6-21: Enable the SSH/SFTP service
6. Click Send.
7. Click Ethernet to display the Ethernet tab and enable, verify, or configure IP parameters. Use
a valid IP configuration to access the device over a network. Configure the device to use a local
point-to-point to connection, as necessary. Click Help for additional details or see section 4.5.
8. Click Send to save any changes.
9. Connect the RMC device to the network or to the laptop or PC (if the Ethernet connection is
local). Keep the serial or USB connection open.
10. Launch the FileZilla application.
11. Click Open the Site Manager. The Site Manager dialog displays
12. Configure the General tab parameters:
• Host: Type the device's IP address.
Port: Type 9696.
•
Protocol: Select SFTP- SSH File Transfer Protocol from the drop-down list.
•
Logon Type: Select Key file from the drop-down list.
•
User: Type root.
•
13. Click Browse to select the current private key. If this is the first time the keys are changed,
use ABB's default developer or technical support private key.
14. Click Connect. If the private key is passphrase-protected, a window displays and requests the
passphrase before granting the connection
1 2 0 | R MC-1 00 | 2 10 5 55 2MN A E
(Figure
(Figure 6-23).
6-22).