Cold Restart From The Device Loader - ABB RMC-100 User Manual

1. Launch PCCU32.
Click the Entry icon.
2.
Click Operate>Communications and select Terminal from the drop-down list
3.
The Terminal screen displays.
Figure 8-32: Terminal menu option
4. Type the BOOT=WARM command at the terminal prompt (->)
Figure 8-33: Terminal mode warm restart
5. Press Enter.
8.5.6

Cold restart from the device loader

This procedure performs the cold start from the 32-bit loader. Follow this procedure on a local or
remote Loader connection. However, ABB highly recommends performing the cold restart locally. The
cold restart causes the device to restart using the startup (cold) configuration.
NOTICE –Loss of data. Perform the procedures in section
configuration before a cold start. This avoids loss of the data and the need for a complete
system reconfiguration. If the startup (cold) configuration does not have the latest network
connection configuration, the restart causes loss of network connectivity. Updating the
startup configuration (tfCold) avoids loss of network connection and reconfiguration.
To complete a cold restart using the startup (cold) configuration:
1. Launch PCCU.
2. Click the 32 Bit Loader icon in the toolbar. A message box displays.
3. Click Yes.
4. Verify or type the connection setup parameters and click Connect. The Loader screen displays.
5. Click Services>Restart in the menu bar, and select Restart using Startup (Cold)
configuration from the drop-down list
1 9 2 | R MC-1 00 | 2 10 5 55 2MN A E
(Figure 8-34).
(Figure
(Figure 8-33).
8.1 Preserve data and
8-32).