Installing The Ce Hood Lock - Toro Reelmaster 5610 Operator's Manual

1. Remove the 3 bolts, washers, and spacers securing the traction manifold to the bottom of the rear
bumper (Figure 33a).
2. Position the appropriate amount of weight on the top and/or bottom of the rear bumper.
3. Mount the weight(s) and the traction manifold to the bumper with the 3 bolts, washers and spacers
previously removed
Note:
Do not use the spacers when installing more than two weights under the bumper
4. Secure the outer edges of the weight(s) to the bumper with 2 carriage bolts and nuts
5

Installing the CE Hood Lock

Parts needed for this procedure:
1 Hood lock, seal, and jam nut
1 Washer
Procedure
1. Unlatch and raise the hood.
2. Remove the rubber grommet from the hole in
the left side of the hood
1. Rubber grommet
3. Ensure that the seal is assembled to the hood
lock (Figure 35).
(Figure 33b).
(Figure 34).
Figure 34
1. Hood latch
2. Nut
4. Remove the nut from the lock.
5. Outside the hood, insert the hook end of the
latch through the hole in the hood.
Note:
The seal is aligned to the outside of the
hood.
6. Inside the hood, Secure the lock to the hood
with the washer and nut.
g004143
7. Close the hood, and use the enclosed hood-latch
key to check that the hook of the lock engages
the frame catch when locked.
21
(Figure
(Figure 33c).
Figure 35
3. Seal
4. Washer
33c).
g375326