Installing The Hood Latch (Ce Only) - Toro Reelmaster 3100-D Operator's Manual

6
Installing the Hood Latch
(CE Only)
Parts needed for this procedure:
1 Lock bracket
2 Rivet
1 Washer
1 Screw (1/4 x 2 inches)
1 Locknut (1/4 inch)
Procedure
1. Unhook the hood latch from the hood-latch
bracket.
2. Remove the rivets (2) securing the hood-latch
bracket to the hood
hood-latch bracket from the hood.
1. Hood-latch bracket
3. While aligning the mounting holes, position the
CE lock bracket and the hood-latch bracket onto
the hood. The lock bracket must be against the
hood (Figure 8). Do not remove the bolt and nut
assembly from the lock bracket arm.
(Figure 7). Remove the
Figure 7
2. Rivets
1. CE lock bracket
4. Align the washers with the holes on the inside of
the hood.
5. Rivet the brackets and the washers to the hood
(Figure 8).
6. Hook the latch onto the hood-latch bracket
(Figure 9).
1. Hood latch
g012628
7. Screw the bolt into the other arm of hood-lock
bracket to lock the latch in position
Note:
Tighten the bolt securely but do not
tighten the nut.
15
Figure 8
2. Bolt and nut assembly
Figure 9
(Figure
g012629
g012630
10).