Draining The Fuel-Water Separator; Bleeding The Fuel System; Checking The Fuel Lines And Connections - Toro Reelmaster 5610 Operator's Manual

Draining the Fuel-Water
Separator
Service Interval: Before each use or daily—Drain
water or other contaminants from
the water separator.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Open the hood; refer to
40).
3. Place a drain pan under the fuel-water separator
filter (Figure 80).
Figure 80
1. Drain valve (fuel-water separator filter)
4. Loosen the drain valve at the bottom of the
fuel-water separator filter, and allow the fuel and
water to drain.
5. Close the drain valve at the bottom of the
fuel-water separator filter.
6. Close and latch the hood; refer to
Hood (page 40).

Bleeding the Fuel System

1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Ensure that the fuel tank is at least half full.
3. Open the hood; refer to
40).
4. Open the air-bleed screw on the fuel-injection
pump (Figure 81).
40).
Opening the Hood (page
g369829
Closing the
40).
Opening the Hood (page
1. Fuel-injection pump bleed screw
5. Turn the key in the ignition switch to the O
position.
The electric fuel pump runs, forcing air out
around the air-bleed screw.
Note:
Leave the key in the O
solid stream of fuel flows out around the screw.
6. Tighten the screw and turn the ignition key to
O .
FF
7. Close and latch the hood; refer to
Hood (page 40).
Checking the Fuel Lines
and Connections
Service Interval: Every 400 hours/Yearly (whichever
comes first)
Park the machine on a level surface, lower the cutting
units, engage the parking brake, shut off the engine,
and remove the key.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Open the hood; refer to
40).
3. Inspect the fuel lines for wear, deterioration,
damage, or loose fittings.
Note:
Repair or replace any worn or damaged
fuel lines; tighten any loose fittings.
4. Close and latch the hood; refer to
Hood (page 40).
47
Figure 81
position until a
N
Closing the
40).
Opening the Hood (page
Closing the
g008891
N