Checking The Hydraulic Lines And Hoses; Replacing The Hydraulic Filters - Toro Reelmaster 5610 Operator's Manual

Figure 101
1. Full mark (dipstick)
3. Remove the cap/dipstick from the filler neck and
wipe it with a clean rag.
4. Insert the dipstick into the filler neck; then
remove it and check the level of fluid.
Note:
The fluid level should be within operating
range on the dipstick.
Important:
Do not overfill the tank.
5. If the level is low, add the appropriate amount of
fluid to raise the level to the full mark.
6. Install the cap/dipstick onto the filler neck.
Checking the Hydraulic
Lines and Hoses
Service Interval: Before each use or daily
Check the hydraulic lines and hoses for leaks, kinked
lines, loose mounting supports, wear, loose fittings,
weather deterioration, and chemical deterioration.
Make all necessary repairs before operating.
Replacing the Hydraulic
Filters
Service Interval: Every 1,000 hours—If you
are using the recommended
hydraulic fluid, replace the
return-hydraulic filter and
charge-hydraulic filter.
Every 800 hours—If you are not using the
recommended hydraulic fluid or have
ever filled the reservoir with an alternative
g376007
2. Add mark (dipstick)
fluid, replace the return-hydraulic filter and
charge-hydraulic filter.
Important:
Use of any other filters may void the
warranty on some components.
Changing the Return Filter
The hydraulic system is equipped with a return
filter-service indicator
the filter-service indicator through the hole in the
floor plate. With the engine running at operating
temperature, check the color of the indicator as
follows:
•
Green indicates normal hydraulic-fluid flow through
the filter.
•
Ref indicates a restricted filter. Change the return
filter.
1. Hydraulic-filter-restriction indicator
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. At the front of the machine, align a drain pan
under the return filter
59
(Figure 102). You view
Figure 102
40).
(Figure 103).
g004132