Servicing The Engine Cooling System - Toro Reelmaster 7000-D Operator's Manual

Note:
The coolant level is correct if it is to the
F mark of the expansion tank.
ULL
6. If the coolant is low, add the specified coolant
to the radiator, expansion tank, or both; refer to
Coolant Specification (page
7. Install the radiator cap and the expansion-tank
cap.
8. Close and latch the hood; refer to
Hood (page 60).
Servicing the Engine
Cooling System
Service Interval: Before each use or daily Clean them
more frequently in dirty conditions.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Unlatch and open the rear screen
Figure 156
1. Latch keeper
3. Clean both sides of the screen.
4. Lift the screen off the hinge pins, and remove
the screen from the machine.
5. Open the hood; refer to
59).
6. Clean both sides of the oil cooler/radiator area
(Figure 157) thoroughly with compressed air.
Start from the front and blow the debris out
81).
Closing the
59).
(Figure 156).
g370476
2. Rear screen latch
Opening the Hood (page
toward the back. Then clean from the back
side and blow toward the front. Repeat the
procedure several times until all chaff and debris
is removed.
Important:
Cleaning the oil cooler/radiator
with water may promote premature corrosion
damage to components and compact debris.
1. Oil cooler/radiator
7. Close and latch the hood,
(page 60).
8. Assemble the screen onto the hinge pins
158).
82
Figure 157
Closing the Hood
g020509
(Figure