Toro Reelmaster 7000-D Operator's Manual page 18
4-wheel drive traction unit
Hide thumbs
Also See for Reelmaster 7000-D:
- Service manual (468 pages) ,
- Operator's manual (144 pages) ,
- Installation instructions (2 pages)
Table of Contents
Advertisement
Preparing to Install the Cutting
Units
1.
Ensure that the countersunk thrust washer is
inserted over the carrier-frame shaft
Figure 24
1. Thrust washer
(countersunk)
2.
Coat the carrier-frame shaft with clean grease
(Figure
25).
Figure 25
1. Carrier-frame shaft
3.
Repeat steps
1
and
Installing the Front Cutting Units
1.
Slide a cutting unit under the lift arm
Figure 26
1. Lynch pin
2. Pivot yoke
(Figure
2. Carrier-frame shaft
2
for the other cutting units.
(Figure
3. Carrier-frame shaft
2.
Insert the shaft of the carrier frame into the pivot
yoke of the lift arm.
3.
Secure the carrier-frame shaft to the pivot yoke
with the lynch pin.
24).
4.
Repeat steps
cutting-unit positions.
Installing the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Higher Height of Cut
1.
Slide a cutting unit under the lift arm
g368731
1. Lift-arm pivot shaft
2. Thrust washer
g367814
(countersunk)
2.
Insert the lift-arm shaft into the lift arm and
secure it with the lynch pin.
3.
Repeat step
Installing the Rear Cutting Units to
26).
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Lower Height of Cut
1.
Remove the lynch pin and washer securing the
lift-arm pivot shaft to the lift arm and slide the
lift-arm pivot shaft out of the lift arm
g368730
18
1
and
3
at the other front
Figure 27
3. Carrier-frame shaft
4. Lynch pin
2
for the other rear cutting unit.
(Figure
27).
g368699
(Figure
28).
Advertisement
Table of Contents
