Toro Reelmaster 7000-D Operator's Manual page 78

Figure 148
1. Traction pedal 3. Stop bolt
2. Mow-speed 4. Short spacers
limiter
4. Position the long spacer above the mow-stop
block.
5. Position the short spacers as you determined
in step 2.
6. Secure the spacers to the mow-stop block
with the stop bolt and flange locknut that you
removed in step 3.
Note:
You must install all 6 short spacers and
the long spacer.
7. Set the mow speed in the InfoCenter; refer to
Setting the Mow Speed in the InfoCenter (page
78).
Setting the Mow Speed in the
InfoCenter
The mow speed setting in the InfoCenter is used by
the TEC to adjust reel speed of the cutting units to the
maximum mow-ground speed.
1. In the InfoCenter, access the M
2. In the M M
AIN ENU
the S option is highlighted, and press the
ETTING
right button.
5. Mow-stop block
6. Flange locknut
M
AIN ENU
, press the middle button until
3. In the S
until the P
and press the right button.
4. In the P
code; refer to
28).
5. In the S
until the M
press the right button.
6. In the M
button or the right button until the mow speed
displayed in the InfoCenter is the same as
the Maximum Mow-Ground Speed that you
determined in step
Speed-Spacers (page
Note:
decreases in 0.8 kph (0.5 mph) increments.
g368822
Note:
Advisory #176 (Reel Speed Changed) displays.
7. Press the left button to exit the Settings menu.
.
78
M , press the middle button
ETTING ENU
M option is highlighted,
ROTECTED ENUS
M screen, enter the PIN
ROTECTED ENUS
Accessing Protected Menus (page
menu, press the middle button
ETTINGS
S option is highlighted, and
OW PEED
S screen, press the middle
OW PEED
2 of Adjusting the Mow
77).
The mow speed setting increases or
Figure 149
The indicator light illuminates and
Figure 150
g368874
g368873