Installing The Hood Lock For Ce; Compliance - Toro Reelmaster 7000-D Operator's Manual

4
Installing the Hood Lock for
CE Compliance
Parts needed for this procedure:
1 Hood-lock bracket
2 Rivet
1 Screw (1/4 x 2 inch)
2 Flat washer (1/4 inch)
1 Locknut (1/4 inch)
Procedure
1. Unhook the hood latch from the hood-latch
bracket (Figure 33).
Figure 33
1. Hood latch
2. Remove the 2 rivets securing the hood-latch
bracket to the hood (Figure 34).
1. Hood-latch bracket
3. Remove the hood-latch bracket from the hood.
4. While aligning the mounting holes, position the
CE lock bracket and the hood-latch bracket onto
the hood.
Note:
The lock bracket must be against the
hood (Figure
Do not remove bolt and nut assembly from the
lock-bracket arm.
g200373
1. CE lock bracket
5. Align the washers with the holes on the inside of
the hood.
6. Rivet the brackets and the washers to the hood
(Figure 35).
7. Hook the latch onto the hood-latch bracket
(Figure 36).
21
Figure 34
2. Rivets
34).
Figure 35
2. Bolt and nut assembly
g012628
g012629