1
Adjusting the Support Rollers
No Parts Required
Procedure
Depending on what width cutting units are to be installed on
the traction, adjust the support rollers as follows:
•
If using 27 inch cutting units, the rollers are to be installed
in the upper mounting holes of support assembly
channels (Figure 3).
•
If using 32 inch cutting units, the rollers are to be
installed in the lower mounting holes of support assembly
channels (Figure 3).
1
1. Support assembly channel 3. Use this hole for 32 inch
2. Use this hole for 27 inch
cutting units
2
g019541
3
Figure 3
cutting units
2
Replacing the Warning Decal
for CE Compliance
Parts needed for this procedure:
1
Warning decal
Procedure
On machines requiring CE Compliance, affix the warning
decal, part no. 120–1683 over the warning decal part no.
120–1686.
3
Installing the Hood Lock for
CE Compliance
Parts needed for this procedure:
1
Hood lock bracket
2
Rivet
1
Screw, 1/4 x 2 inch
2
Flat washer, 1/4 inch
1
Locknut, 1/4 inch
Procedure
1. Unhook the hood latch from the hood latch bracket
(Figure 4).
14