Connecting E1/T1 Cables - Huawei Airbridge BTS3606 Installation Manual

Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
4) Check whether there is any space between waterproof modules.
If yes, use silicon gel to block it.
5) Restore the shielding clip to its original position, as shown in Figure 5-32.
(1) E1/T1 cable (2) Shielding clip
Figure 5-32 Shielded E1/T1 cable

5.4.4 Connecting E1/T1 Cables

To connect E1/T1 cables, proceed as follows:
1) Connect one DB25 connector of each E1/T1 cable to the DB25 socket on the
BESP according to the label on the E1/T1 cable and the label on the DB25 socket
(in the sequence of E1/T1_0, E1/T1_1, E1/T1_2, and E1/T1_3). See Figure 5-33.
Caution:
Do not leave any silicon gel on the shielding clip or the shielding layer of the
E1/T1 cable.
Keep the shielding layer intact when peeling off the outer skin of the cable.
Peel off enough outer skin to ensure that the shielding layer is in complete
contact with the shielding clip.
(1)
Huawei Technologies Proprietary
(2)
5-31
Chapter 5 Installing Cables