Table of Contents
Advertisement
Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
3.2.5 Removing Lugs
After the cabinet is installed, remove the lugs. Use the filler blocks delivered with the
equipment to fill the holes on the lugs and then keep the lugs in the tool box.
3.3 Installation and Removal of BTS3606A Cabinet Front
Door
The front and rear doors of the BTS3606A cabinet have been installed before delivery.
The following describes how to remove cabinet doors. You can follow the reverse order
to install the doors.
3.3.1 Removing Front Door
Caution:
The front door is large and heavy. You need lifting equipment such as a lifting jack to
install or remove it.
Avoid tipping over the front door when installing or removing the front door.
Accidents may result.
The air-conditioner is attached inside the front door. Therefore, never put the front
door flatly on the ground during the installation or removal.
Make sure the angle between the vertical plane and the front door is laid vertical or
the slope angle is less than 20°.
To remove the front door, proceed as follows:
1)
Remove all the cables and hinges on the front door.
2)
Remove the bolts of the support bar on the front door.
3)
Lift the support bar from the rail on the front door.
4)
Remove the circlip on the latch.
5)
Lift the front door lightly using the lifting equipment.
6)
Remove the latch from the side of the front door.
7)
Lift the front door vertically.
3.3.2 Removing Rear Door
The rear door of the cabinet is normally not removed during the routine maintenance.
But if the cabinet cannot be lifted, remove the rear door to reduce the weight of the
cabinet for transportation.
Chapter 3 Installing Cabinet and Cabinet Equipment
Huawei Technologies Proprietary
3-11
- Quick Links:
- Table 1-1 Technical Documents
Hide quick links:
Advertisement
Table of Contents
