Mitsubishi Electric MELSERVO-J2S Series Manual page 98

(６) Mounting the Terminal Block
You are going to mount the terminal
block you removed in advance to the
TE bracket ①.
Arrangement of
the Terminals
TE2
L L D P
11 21
TE1
L L L U
1 2 3
・A schematic view seen from the front
side of the amplifier
・Terminal screw: M4
・Tightening torque: 1.2 [N·m]
(７) Connecting the Cables to the Replacing Servo Amplifier
①Check the names of the cables that are to be housed in Renewal
Kit. Check the abbreviations and short names of the connectors
to the servo amplifier. Connect the cables and the connectors.
* In the case of terminal block TE1 or 2, connect the cables,
starting from the left side of the amplifier.
①Cables to be housed in Renewal Kit
Use the cable connector that comes with the
servo amplifier for wiring. For the details of
how to connect the cables, see "Model
MR-J4-_A(-RJ) SERVO AMPLIFIER INSTRUCTION
MANUAL" issued by Mitsubishi Electric
Corporation.
* For the connections of the built-in
regeneration resistance, the regeneration
option, and the power regeneration converter,
see section 3.3.4, paragraphs (11), (12), and
(13).
Use the cable tie (an accessory in the package) to
tie up and fasten the cables in Renewal Kit.
* When mounting the bracket, pay attention to the direction
C N
V W
Bracket TE
When a battery is not used
(an incremental system)
of the terminal block.
If you try to mount it in an incorrect direction, you cannot mount
it correctly. Be careful.
Terminal
block TE2
Terminal
block TE1
３-２１
3 － 21
Bracket TE
When a battery is used
(absolute position detection system)