Mitsubishi Electric MELSERVO-J2S Series Manual page 85

（８）Connecting the Conversion Cable and the Currently Used Cable
・Type of the servo amplifier: The case of Type A with the amplifier capacity of 7kW or lower
You are going to connect the currently used cable to the conversion cable.
CAUTION
The connectors (CN1A, CN1B, CN2, and CN3) on servo amplifier MR-J2S-_A are all in the same shape.
If you connect a currently used cable to a wrong connector and turn on power, the amplifier, the motor,
and/or the like may be broken due to the difference in voltage.
Side of the Conversion Cable
変換ケーブル側
制御信号変換ケーブル
Control signal conversion cable
（SC-J2SJ4CTC03M）
エンコーダ変換ケーブル
Encoder conversion cable
（SC-J2SJ4ENC03M）
モニタ変換ケーブル
Monitor conversion cable
（SC-J2SJ4MOC03M）
CAUTION
●The connectors (CN1A, CN1B, CN2, and CN3) on the conversion cable
are all in the same shape. Use caution not to make an incorrect
connection. If you make an incorrect connection, the servo
amplifier may be broken.
The connectors are all in the same
shape. Use caution not to make an
incorrect connection.
●
Do not fasten the encoder conversion cable and the control signal
conversion cable on a power cable or on a drive cable. Dosing so may cause
an incorrect operation.
Use cable ties (accessories in the package) to fasten and fix the cables
on the control signal conversion cable of Renewal Kit or on the currently
used control signal connection cable.
Side of the Currently Used Cable
３-８
3 － 8
既設ケーブル側
CN1A用
For CN1A
Currently used control
既設制御信号ケーブル
signal cable
CN1B用
For CN1B
Currently used encoder
既設エンコーダケーブル
cable
Currently used monitor
既設モニタケーブル
cable