Mitsubishi Electric MELSERVO-J2S Series Manual page 82

(３)Mounting the TE1 Bracket
Use the screws (M3 × 6; 2 screws) that come as accessories in the package to mount, depending on whether
a battery is used or not, the TE1 bracket ① that you in advice removed the terminal block from.
①TE1 bracket
When a battery is not used
(in the case of an incremental system)
(４) Mounting the Terminal Block
Mount the terminal block that you
removed in advance on the TE1 bracket①.
①TE1 bracket
Arrangement of
the Terminals
TE1
L L L
1 2 3
U V W
Note
A schematic view seen from the
front side of the amplifier
(in the case of an incremental system)
When a battery is not used
When a battery is used
(in the case of an absolute position
detection system)
* When mounting the bracket, pay attention to
the direction of the terminal block.
If you try to mount it in an incorrect direction, you
cannot mount it correctly. Be careful.
①TE1 bracket
(in the case of an absolute position
３-５
3 － 5
①TE1 bracket
Battery option
「MR-BAT6V1SET」
When a battery is used
detection system)