Backlapping - Toro Reelmaster 5200-D Service Manual

Backlapping

DANGER
Reels may stall while backlapping. Do not at-
tempt to restart reels by hand or adjust while
backlapping. Stop engine and set speed control
to position 11 to the start reels; set to position 1
for backlapping.
NOTE: Backlap either the front cutting units together or
the rear ones together.
1. Park machine on a clean, level surface. Lower cut-
ting units, stop engine, engage parking brake, move en-
able/disable switch to disable position, and remove key
from the ignition switch.
2. Unlock and raise seat to expose controls.
3. Make initial reel to bedknife adjustments appropriate
for backlapping on all cutting units. Start engine and set
engine at idle speed.
4. Set both reel speed controls to position 11 (Fig. 21).
5. Select either front or rear on backlap switch to deter-
mine which units to backlap (Fig. 22).
6. Move enable/disable switch to enable position.
Move lower mow/raise lever forward to start backlap-
ping operation on designated reels (Fig. 23).
7. For the cutting units being backlapped, move the reel
speed control to position 1.
Reelmaster 5200-D/5400-D
1. Front reel speed control
1
1. Backlap switch
2
1. Enable/Disable switch
Page 8 - 15
Rev. A
2
1
Figure 21
2. Rear reel speed control
2
Figure 22
2. Radiator screen
1
Figure 23
2. Lower Mow/Raise lever
Cutting Units
(Model 03506, S/N 80001 - 209999999)
(Model 03509, S/N 80001 - 209999999)