Reel Motor - Toro Reelmaster 5200-D Service Manual

Reel Motor

1
2
17 ft–lb
(23 N–m)
14
1. Socket head screw
2. Washer
3. Dowel pin
4. Cover
5. Needle bearing
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Disconnect hydraulic lines. Put caps or plugs on fit-
tings and hoses to prevent contamination. Tag hydraulic
lines for proper reassembly.
3. Loosen motor mounting nuts (Fig. 91).
4. Rotate motor clockwise so motor flanges clear studs
and pull motor out.
Installation
1. Place motor into position on mounting studs. Rotate
motor counterclockwise so motor flanges lock to studs.
2. Tighten motor mounting nuts
Hydraulic System
3
4
5
6
7
Figure 90
6. Idler gear
7. Drive shaft
8. Ring seal
9. Load plate
10. Body
Page 4 - 68
8
9
5
11. Spacer
12. Shaft seal
13. Retaining ring
14. Dowel pin
1
Figure 91
1. Reel motor
3. Remove caps or plugs from fittings and hoses. Con-
nect hydraulic lines lines to the motor.
5
10
11
12
13
2
2. Motor mounting nut
Reelmaster 5200-D/5400-D