Special Tools; Special Tools - Toro Reelmaster 5200-D Service Manual

Special Tools

Order special tools from the TORO SPECIAL TOOLS
AND APPLICATIONS GUIDE (COMMERCIAL PROD-
UCTS).
Gauge Bar Assembly
Use gauge bar to verify height of cut and bedknife atti-
tude.
Toro P/N 98-1852
Angle Indicator
Use with Gauge Bar Assembly to verify bedknife atti-
tude.
Toro P/N 99-3503
Bedknife Screw Tool - TOR510880
This screwdriver-type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a torque wrench to se-
cure the bedknife to the bedbar. Make sure bedbar
threads are clean and use new screws. Tighten screws
to a torque of 250 - 300 in.lb. (28 - 34 Nm) starting in the
middle of the bedknife (Fig. 34).
NOTE: Remove all rust, scale and corrosion from bed-
bar surface before installing bedknife.
DO NOT use and air impact wrench with this tool.
Reelmaster 5200-D/5400-D
Some tools may have been supplied with your machine
or available as TORO parts. Some tools may also be
available from a local supplier.
Page 8.1 - 3
Rev. A
Used only with
Adjustable Front Height of Cut Kit
Figure 2
Figure 3
Figure 4
Cutting Units
(Model 03527, S/N 210000001 & Up)
(Model 03528, S/N 210000001 & Up)