Toro Reelmaster 5200-D Service Manual page 9

Maintenance and Service
22.Before servicing or making adjustments, stop engine
and remove key from the switch.
23.Make sure machine is in safe operating condition by
keeping all nuts, bolts and screws tight.
24.Make sure all hydraulic line connectors are tight, and
all hydraulic hoses and lines are in good condition be-
fore applying pressure to the system.
25.Keep body and hands away from pin hole leaks in hy-
draulic lines that eject high pressure hydraulic fluid. Use
cardboard or paper to find hydraulic leaks. Hydraulic
fluid escaping under pressure can penetrate skin and
cause injury. Fluid accidentally injected into the skin
must be surgically removed within a few hours by a doc-
tor familiar with this form of injury or gangrene may re-
sult.
26.Before disconnecting or performing any work on the
hydraulic system, all pressure in system must be re-
lieved by stopping engine and lowering cutting units to
the ground.
27.If major repairs are ever needed or assistance is de-
sired, contact an Authorized Toro Distributor.
28.To reduce potential fire hazard, keep engine area
free of excessive grease, grass, leaves and dirt. Clean
protective screen on front of engine frequently.
29.If engine must be running to perform maintenance or
an adjustment, keep hands, feet, clothing and other
Reelmaster 5200-D/5400-D
parts of the body away from cutting units and other mov-
ing parts. Keep everyone away.
30.Do not overspeed the engine by changing governor
setting. To assure safety and accuracy, have an Autho-
rized Toro Distributor check maximum engine speed.
31.Shut engine off before checking or adding oil to the
crankcase.
32.Disconnect battery before servicing the machine. If
battery voltage is required for troubleshooting or test
procedures, temporarily connect the battery.
33.At the time of manufacture, the machine conformed
to the safety standards for riding mowers. To assure op-
timum performance and continued safety certification of
the machine, use genuine Toro replacement parts and
accessories. Replacement parts and accessories made
by other manufacturers may result in non-conformance
with the safety standards, and the warranty may be
voided.
34. When changing attachments, tires, or performing
other service, use correct blocks, hoists, and jacks.
Make sure machine is parked on a solid level floor such
as a concrete floor. Prior to raising the machine, remove
any attachments that may interfere with the safe and
proper raising of the machine. Always chock or block
wheels. Used jack stands or solid wood blocks to sup-
port the raised machine. If the machine is not properly
supported by blocks or jack stands, the machine may
move or fall, which may result in personal injury (see
Jacking Instructions).
Page 1 - 3
Safety