Front Grass Shield Adjustment
Adjust front grass shield for desired grass clippings dis-
persion.
1. Position cutting unit on a flat level surface.
2. Loosen capscrews and nuts securing shield to each
side plate. Move shield to desired angle and tighten fas-
teners (Fig. 20).
Rear Shield Adjustment
Under most conditions, best dispersion is attained when
rear shield is closed (front discharge). When conditions
are heavy or wet, rear shield may be opened.
1. To open rear shield, loosen flange head capscrew
securing shield to right side plate, rotate shield to open
position and tighten screw (Fig. 21).
Cut-Off Bar Adjustment
The Cut–Off bar is designed to keep the gap between
the reel and the Cut–Off minimal to insure grass clip-
pings discharge cleanly from reel area.
Note: The gap between the Cut–Off bar and reel will
increase as: 1) the reel wears, 2) reel is sharpened by
grinding, or 3) if the front grass shield is adjusted.
1. Loosen screws securing Cut–Off bar (Fig. 22). Insert
0.060" (2 mm) feeler gauge between top of reel and
Cut–Off bar.
Reelmaster 5200-D/5400-D
2
1. Front grass shield
1. Rear grass shield mounting screw
2
1. Cut-off bar
Page 8.1 - 13
Rev. A
1
Figure 20
3. Capscrew & nut
1
Figure 21
1
Figure 22
3. Screw (4)
Cutting Units
(Model 03527, S/N 210000001 & Up)
(Model 03528, S/N 210000001 & Up)