Backlapping Information - Toro Greensmaster eFlex 1021 Operator's Manual

Removing the Cutting Unit (continued)
4. Slide the hex tube
coupler shaft
5. Move the suspension latches
the cutting unit from the machine.
6. Remove the cutting unit from the frame.

Backlapping Information

To backlap the cutting unit, perform 1 of the following options:
• Install the Access Backlap Kit (Model 139-4342) and use a backlapping machine.
Contact your authorized distributor to acquire this kit.
• Use the InfoCenter to enter Backlap Mode.
To enter Backlap Mode, select B
prompts to backlap the cutting unit.
Note:
catch fork
Remove the bail-catch fork after your backlapping is completed.
off of the cutting-unit
.
Once the bail is released, Backlap Mode is disengaged. You can use the bail-
(shipped in the loose-parts bag) to secure the bail in the engaged position.
up to release
G404931
from the S
ACKLAP ERVICE
10
menu. Follow the InfoCenter