Toro Reelmaster 5200-D Service Manual page 278

Bevel Gear Case and Axle Case
The following procedures assume the rear axle assem-
bly has been removed from the machine.
Removal
1. Remove the mounting screws, nuts, and lock wash-
ers. Remove the bevel gear case/axle case assembly
and O-ring from the axle support (Fig. 11).
2. Mark both right and left bevel gear case/axle case
assemblies.
IMPORTANT: Do not interchange right and left
bevel gear case/axle case assemblies.
3. Remove the axle cover mounting screws. Remove
the axle cover from the axle case as an assembly
(Fig. 12).
4. Remove the axle case support mounting screws, the
axle case support, and the support shims (Fig. 13).
4WD Rear Axle
(Unit Serial No. 200000001 & Up)
4
2
1. Cap screw
2. Lock nut
3. Lock washer
4. Axle support
1. Axle case
2. Axle cover assembly
2
1. Axle case
2. Axle case support
Page 9.1 - 10
Rev. A
1
6
3
Figure 11
5. Bevel gear case/axle
case assembly
6. O-ring
1
4
2
Figure 12
3. Mounting screw
4. O-ring
3
4
Figure 13
3. Mounting screw
4. Support shim
Reelmaster 5200-D/5400-D
5
3
1