General Run & Transport Problems; Cutting Unit Operating Problems - Toro Reelmaster 5200-D Service Manual

General Run and Transport Problems
Engine continues to run, but should not, when the
ignition switch is turned off.
Engine continues to run, but should not, when the
traction pedal is engaged with no operator in the seat.
The engine stops during operation, but is able to
restart.
The engine kills when the traction pedal is depressed
Battery does not charge.

Cutting Unit Operating Problems

The cutting units remain engaged, but should not, with
no operator in the seat.
Cutting units run, but should not, when raised. Units
shut off with enable disable switch.
Cutting units run, but should not, when raised. Units do
not shut off with the enable disable switch.
Cutting units run, but should not, when lowered with
enable/disable switch in the disable position.
The front cutting units do not operate in either
direction. Units are able to raise and lower.
Electrical Systems
The engine run (ETR) solenoid is stuck open.
Ignition switch or circuit wiring is faulty.
The seat sensor or circuit wiring is faulty.
Traction neutral switch or circuit wiring is faulty.
The parking brake is engaged.
The seat sensor actuator is lifting off the seat switch.
The seat sensor or circuit wiring is faulty.
The ignition switch or circuit wiring is faulty.
Not an electrical issue, check fuel delivery system.
The parking brake is engaged.
The seat sensor actuator is lifting off the seat switch.
The seat sensor or circuit wiring is faulty.
Loose or broken wire(s).
The fusible link to the battery is faulty.
Faulty alternator or dead battery.
Alternator warning lamp is faulty or burned out.
Alternator warning lamp wiring loose, corroded, or
damaged.
The seat sensor or circuit wiring is faulty.
The front reels down sensor or circuit wiring is faulty.
Both the front reels down sensor or circuit wiring, and
enable/disable switch or circuit wiring are faulty.
A hydraulic problem exists (see Troubleshooting
section of Chapter 4 - Hydraulic System).
The enable/disable switch or circuit wiring is faulty.
Solenoid S1 or circuit wiring is faulty.
A hydraulic problem exists (see Troubleshooting
section of Chapter 4 - Hydraulic System).
Page 5 - 8
Rev. A
Reelmaster 5200-D/5400-D