Table of Contents
Advertisement
Electrical requirements
Before inserting the plug into the wall socket
make sure that the voltage and the frequency
shown in the rating plate inside the appliance
corresponds to your electricity supply.
Ensure that the plug remains readily
accessible. Do not use multiple adapter bar
or extension cable.
Warning! This appliance must be
earthed.
Repairs to electrical equipment should only be
performed by a qualified technician. Incorrect
repairs carried out by an unqualified person
risks that may have critical consequences for
the user of the appliance.
Transportation
instructions
1. The appliance should be transported only
in upright position. The packing as supplied
must be intact during transportation.
2. If during the course of transport the appliance,
has been positioned horizontally, it must not
be operated for at least 4 hours, to allow the
system to settle.
3. Failure to comply with the above instructions
could result in damage to the appliance, for
which the manufacturer will not be liable for.
4. The appliance must be protected against
rain, moisture and other atmospheric influences.
Important!
• Do not attempt to sit or stand on top of your
appliance as it is not designed for such use.
You could injure yourself or damage the
appliance.
• Make sure that the mains cable is not caught
under the appliance during and
after moving, as this could damage the cable.
• Do not allow children to play with the
appliance or tamper with the controls.
Instructions for use
Installation instructions
1. Do not keep your appliance in a room where
the temperature is likely to fall below 10 ° C
at night and/or especially in winter, as it is
designed to operate in ambient temperatures
between +10 and +43 ° C. At lower
temperatures the appliance may not operate,
resulting in a reduction in the storage life of
the food.
2. Do not place the appliance near cookers or
radiators or in direct sunlight, as this will cause
extra strain on the appliance's functions. If
installed next to a source of heat or freezer,
maintain the following minimum side clearances:
From Cookers 30 mm
From Radiators 300 mm
From Freezers 25 mm
3. Make sure that sufficient room is provided
around the appliance to ensure free air
circulation.
• The lower air-circulation cover inside your
refrigerator should be placed below the door,
by facing the counter parts as seen in(Fig. 2).
Be sure that the counter parts meshed completely.
•For efficient functioning, there should be a
gap of at least 5 cm between the refrigerator
and the wall. To ensure this, attach the two
round buffers to be found inside the No Frost
appliance, as shown in the illustration(Fig. 3).
4. The appliance should be positioned on a
smooth surface. The two front feet can be
adjusted as required. To ensure that your
appliance is standing upright adjust the two
front feet by turning clockwise or anti-clockwise,
until firm contact is secured with the floor.
Correct adjustment of feet prevents excessive
vibration and noise.
5. Refer to "Cleaning and Care" section to
prepare your appliance for use.
2
Advertisement
Table of Contents
