GE FVP110 Maintenance Manual page 216

GE Energy
Relative Index Parameter
Index
18 5018 SP_RATE_
DN
19 5019 SP_RATE_
UP
20 5020 SP_HI_LIM
21 5021 SP_LO_LIM
22 5022 CHANNEL
23 5023 FSTATE_
TIME
24 5024 FSTATE_VAL
25 5025 BKCAL_OUT
26 5026 RCAS_IN
27 5027 SHED_OPT
28 5028 RCAS_OUT
Table 62 AO Block Parameters (Continued)
Default
Name (factory
setting)
+INF
+INF
100
0
1
0 second
0
–
–
1
–
FVP 110 Fieldbus Valve Positioner Manual
Write
Rate-of-decrease limit for SP effective in
AUTO, CAS, and RCAS modes. If this
parameter is 0, no limit is applied to the rate of
decrease.
Rate-of-increase limit for SP effective in AUTO,
CAS, and RCAS modes. If this parameter is 0,
no limit is applied to the rate of increase.
Upper limit for setpoint (SP)
Lower limit for setpoint (SP)
O/S
Defines the channel number of the
hardware channel connected to the
transducer block. Always set to 1 for the
AO block in a FVP110.
Defines the time from when the fault state
of the RCAS_IN or CAS_IN is detected to
when the output should be set to the level
preset in FSTATE_VAL (this action takes
place only if Fault State to value is set as
true in I/O_OPTS).
Preset output level for fault state. See
above.
—
Value to be input to BKCAL_IN of the
downstream block; used by the
downstream block to prevent reset windup
and perform bumpless transfer to
closed-loop control.
Remote cascade setpoint set by the host
computer, etc.
Defines the mode shedding action to be
taken upon occurrence of time-out of
communication in a mode using the
remote setpoint.
—
Remote setpoint sent to a host computer,
etc.
200
Description