GE FVP110 Maintenance Manual page 209

Parameters of Transducer Block
Relative Index Parameter
Index
54 2054 VALVE_HYS
55 2055 VALVE_SLIP
_WIDTH
56 2056 MEAS_
PRESS_AIR
57 2057 MEAS_
PRESS
_SUPPLY
58 2058 MEAS_
SPRING
_RANGE
59 2059 CONTROL_
DIR
60 2060 THETA_HI(*1)
(*2)
61 2061 THETA_LO
(*1)(*2)
62 2062 THETA_P(*1)
(*2)
63 2063 TRAVEL_
CALIB
_EXEC
64 2064 TRAVEL_
CALIB
_RESULT
65 2065 OPEN_STOP
_ADJ
66 2066 AUTO_TUNE
_EXEC
Table 61 Transducer Block Parameters (Continued)
Default
Name (factory
setting)
0 %
0 %
0 kPa
0 kPa
0 kPa
2
+ 0.2 rad.
-0.2 rad.
0 rad.
1
1
–
1
Write
— Hysteresis of valve actions (%); a parameter
set by auto tuning
— Slip width of valve actions (%); a parameter set
by auto tuning
— Air pressure (%); a parameter set by auto
tuning (Valid when an optional pressure sensor
is specified.)
— Air supply pressure (%); a parameter set by
auto tuning (Valid when an optional pressure
sensor is specified.)
— Spring range of valve; a parameter set by auto
tuning (Valid when an optional pressure sensor
is specified.)
— Defines the acting direction of the feedback
loop:
1 = direct
2 = reverse
— Upper angle signal limit of position sensor (in
radians)
— Upper angle signal limit of position sensor (in
radians)
— Angle signal equal to 50 % from position
sensor (in radians)
O/S Switch for starting a travel calibration.
— Indicates the result of a travel calibration.
— Not used for FVP110.
O/S Switch for starting auto tuning.
193
Function Block Parameters
Description