Creating New Bullseye Data Instances - ABB BullsEye Applications Manual

5.3.5 Creating new BullsEye data instances

Introduction
The default be_device, be_tooldesign, and be_scan data instances provided
with BullsEye cannot be changed because the module is declared as a read-only
resource. Suppose the default parameters provided do not support the BullsEye
setup in your system. A common parameter that sometimes requires a change is
the Signal Name. The BullsEye scanning device is wired to a digital input in the
controller. The signal name used in BullsEye must match the signal name defined
in system parameters. Creating a new be_device data instance allows us to make
that change.
Application manual - BullsEye
3HAC050989-001 Revision: C
© Copyright 2004-2018 ABB. All rights reserved.
5.3.5 Creating new BullsEye data instances
Continues on next page
5 User guide
41