Huawei FusionModule1000A20 Maintenance Manual page 24

FusionModule1000A20 CT Solution
Maintenance Guide
Categ
ory
ution
System
ECC80
0
WebUI
Issue 01 (2019-02-25)
Mainten Operation
ance
Item
Check whether
the indicators are
normal.
Check whether
the ground points
properly connect
to the equipment
room ground bar.
PDC Check the
luminance of the
indicators.
Check the SPD
indicator and
SPD circuit
breaker status.
FusionMo On the ECC800
dule1000 WebUI, choose
alarms Home > Active
Alarms or
Query >
Historical
Alarms.
Copyright © Huawei Technologies Co., Ltd.
Check Troubleshooting
Standard
All indicators Rectify the fault by
are normal. referring to
TP48200B-N20B2 &
TP48200B-N20B3 &
TP48200B-L20B2 &
TP48400B-N20B3 &
TP48400B-L20B1
V500R002 User Manual.
The cable Secure the ground point or
between the replace the ground cable.
power system
ground point
and the
equipment room
ground bar is
securely
connected.
The three-phase If an indicator is off or dim,
power indicators replace it. For details, refer
are steady on. to 5.1.2.5 Replacing an
Indicator.
The SPD If the SPD indicator is red,
indicator is replace the SPD. For
green. details, refer to 5.1.2.4
Replacing an SPD.
1. If the SPD indicator is
The SPD circuit
breaker is
switched to ON.
2. Switch on the circuit
No alarm is Refer to ECC800 Data
displayed in the Center Controller
alarm V100R001C30 User
information Manual or iManager
area. NetEco documentation.
Alarm short Check whether the SIM
messages can be card is properly installed. If
received. the SIM card is faulty,
replace it by following
instructions in ECC800
Data Center Controller
V100R001C30 User
Manual.
3 Routine Maintenance
red, replace the SPD.
For details, refer to
5.1.2.4 Replacing an
SPD.
breaker.
17