NEC ASPILA EX Feature Manual page 479

Description (Cont'd)
Dial Types
Default
Aspila EX Software Manual
Step 2: Specify the length of the code you want to change
After you specify a single or two digit code, you must tell the system how many digits com-
prise the code. This is the Number of Digits Required column in the System Numbering
(page 474) table. In the default program, all codes from 100-999 are three digits long. Codes
beginning with 0 are one digit long. Codes beginning with * are 3 digits long and codes begin-
ning with # are 4 digits long.
Step 3: Assign a function to the code selected
After entering a code and specifying its length, you must assign its function. This is the Dial
Type column in the System Numbering (page 474) table. The choices are:
Dial Type Description
0 - Not Used -
1 Service Code
2 Extension Number
3 Trunk Access Code
4 Special Trunk Access
5 Operator Access
6 ARS/F-Route Access
Changing the Dial Type for a range of codes can have a dramatic affect on how your sys-
l
tem operates. Assume, for example, the site is a hotel that has room numbers from
100-399. In order to make extension numbers correspond to room numbers, you should:
- In Program 11-02, reassign extension numbers on each floor from 100 to 399.
(Other applications might also require you to change entries in
Program 11-10 through 11-16.)
See the following tables.
Program 11 : System Numbering
11-01 : System Numbering
11-10 : Service Code Setup (for System Administrator)
11-11 : Service Code Setup (for Registration)
11-12 : Service Code Setup (for Service Access)
11-13 : Service Code Setup (for ACD)
11-14 : Service Code Setup (for HOTEL)
11-15 : Service Code Setup (Special access)
11-02 : Extension Numbers
11-04 : Virtual Extension Numbers
11-06 : 2PGDAD (ACI) Extension Numbers
11-07 : Department Calling Group Numbers
11-08 : 2PGDAD (ACI) Group Pilot Numbers
11-09 : Trunk Access Code.
11-09 : Trunk Access Code.
20-17 : Operator's Extension
44-xx
Related Program
Programming 473