NEC ASPILA EX Feature Manual page 414

Introduction to Programming
Before You Start Programming
How to Enter the Programming Mode
Password
12345678
408 Programming
Telephone Programming Instructions shows you how to enter the program's data into system
memory. For example:
1. Enter the programming mode.
2. 15-07-01
15-07-01 TEL200
KY01 = *01
¬
tells you to enter the programming mode, dial 150701 from the telephone dial pad. After you do,
you'll see the message "15-07-01 TEL200" on the first line of the telephone display. This indicates
the program number (15-07), item number (01), and that the options are being set for extension
200. The second row of the display "KY01 = *01" indicates that Key 01 is being programmed with
the entry of *01. The third row allows you to move the cursor to the left or right, depending on
which arrow is pressed. To learn how to enter the programming mode, see How to Enter the Pro-
below.
gramming Mode
Depending on the mode of programming, the system may allow more than one person in the pro-
gramming mode at one time. With telephone programming, two people can program simulta-
neously. Using the PC Program, only one person is allowed in programming. With the Web
Program, up to four people can be programming the system at once. If the same program number is
being defined simultaneously, the last changes made to the program will be accepted.
To enter the programming mode:
1. Go to any working display telephone.
In a newly installed system, use extension 200 (port 1).
2. Do not lift the handset.
3. Press CALL1.
4. # * # *
Password
5. Dial the system password + HOLD.
Refer to the following table for the default system passwords. To change the pass-
words, use Program 90-02.
Level
2 (IN)
0000 3 (SA)
9999 4 (SB)
®
Programs at this Level
All programs in this section not listed below for SA and SB
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17, 10-18,
10-22, 12-02, 12-03, 12-04, 15-01, 15-07, 15-09, 15-10, 15-11,
20-16, 21-07, 21-14, 22-04, 22-11, 25-08, 30-03, 32-02, 40-02,
41-02, 41-03, 41-04, 41-05, 41-06, 41-07, 41-08, 41-09, 41-10,
41-11, 41-12, 41-13, 41-14, 41-15, 41-16, 41-17, 41-18, 90-03,
90-04, 90-06, 90-07, 90-18, 90-19
13-04, 13-05, 13-06
Aspila EX Software Manual