NEC ASPILA EX Feature Manual page 253

Programming
Related Features
Aspila EX Software Manual
•14-05-01 : Trunk Groups
Assign trunks to trunk groups (1-100). In general, loop keys access trunks within specific
trunk groups.
•14-07-01 : Trunk Access Map Setup
Set up the Trunk Access Maps. For example, if an extension's loop key is for incoming and
outgoing, make sure the Trunk Access Map allows incoming and outgoing access. Also see
Program 15-06 below.
•15-06-01 : Trunk Access Map for Extensions
Assign Trunk Access Maps to extensions. Also see Program 14-07 above.
•15-07-01 : Programming Function Keys
Program function keys as trunk group/loop keys (*02 or *05). For additional data, in Program
15-13 enter 0 (incoming only), 1 (outgoing only) or 2 (both ways).
•15-13-01 : Loop Keys
For each loop key on an extension, program options for Data 1 and Data 2 (see the chart below).
Data 1
Outgoing Options
0 Assigns the loop key for ARS
1-100 Assigns the loop key to the trunk
group specified
•20-07-10 : Class of Service Options (Administrator Level), Programmable Function Key
Programming (Appearance Level)
If an extension should be able to use Programmable Functions Keys to program a loop key,
enable this option in the user's Class of Service (1-15).
•22-04-01 : Incoming Extension Ring Group Assignment
Assign extensions to Ring Groups (1-100). An incoming loop key will ring only for those
trunks programmed to ring. Also see Program 22-05.
•22-05-01 : Incoming Trunk Ring Group Assignment
Assign trunks to Ring Groups (1-100). An incoming loop key will ring only for those trunks
programmed to ring. Also see Program 22-04 above.
Automatic Route Selection (ARS) / Central Office Calls, Answering / Central Office
Calls, Placing
Program incoming and outgoing access and routing options.
Off Hook Signaling
If enabled, a user hears Call Waiting beeps if additional calls are waiting behind a loop key.
Programmable Function Keys
If you have a line and loop key for the same trunk, the line key has precedence. An incoming
call rings the line key, not the loop key. When you press the loop key for an outgoing call, the
line key lights.
Ring Groups
Trunks ring telephones according to their Ring Group assignments (Programs 22-04 and 22-05).
Direct Inward Dialing (DID) / Direct Inward Line (DIL) / Direct Inward System Access
(DISA) / Tie Lines
access
1-100
Data 2
Incoming Options
0 Assigns the loop key to all trunk groups
Assigns the loop key to the trunk group
specified
Loop Keys
Features 239