Rear Roller Replacement - GE T2100 Service Manual

Rear Roller Replacement

7-8
Assembly/Disassembly: Rear Roller Replacement
1. Turn the power switch off and disconnect the power cord from the
wall outlet.
2. Remove the walking belt tension bolts on the end of the GE T2100
Treadmill and remove the end caps.
Tension Bolts
3. Locate the roller bolt access holes and remove the 9/16-inch bolt from
one side.
4. While supporting the free end of the roller, remove the
9/16-inch bolt on the opposite side of the GE T2100 Treadmill.
5. Lift the roller up and slide it out of the belt.
6. Install the new roller in reverse order, and then adjust the walking
belt tracking and tension. See
page 4-5.
7. Calibrate the GE T2100 Treadmill. See
10."
GE T2100 Treadmill
2021403-031
"Walking Belt Tension Adjustment"
"Self-Calibration"
021
on
on page 3-
Revision A