Samsung OfficeServ 7400 Technical Manual page 63

OfficeServ 7400
TECHNICAL MANUAL
POWER UP PROCEDURE FOR SVMi-20E
Follow the steps below to ensure that the SVMi-20E is properly setup.
POWER UP
1. Complete insertion of the SVMi-20E and all other required interface cards and
turn the system power switch ON.
2. There are 8 LEDs on the front of SVMi-20E. We will watch three during power
up., the PGD, HDD, and the SDN LEDs:
POWER UP LED CONFIRMATION
• The PGD LED- will show steady green when the SVMi-20E is receiving Power from
the OfficeServ 7000 Series Back Plane connectors.
• The HDD LED- will show hard drive access and will flicker whenever the HDD (hard
drive) is being accessed.
• The SDN LED – will start off Green as the SVMi-20E is booting up (it will also turn
Green when the SVMi-20E is shut down properly). It will turn Orange after the Voice
Drivers are loaded into memory and then turn RED when the application Software is
fully loaded. RED is warning letting you know the application is running and it is
NOT safe to power down the OfficeServ 7000 Series System.
SETTING UP THE SVMI-20E WITH THE OFFICESERV 7000
SERIES PHONE SYSTEMS
This section provides the additional steps required to set up the SVMi-20E card for
operation in the OfficeServ 7000 Series telephone system products. Included here is
information regarding the software set up for the phone system.
After inserting the SVMi-20E card and turning the power on there are some key system
options that should be set, in order for the SVMi-20E to function correctly. These steps
are performed in the phone system. It is necessary to perform these at this time so that
the SVMi-20E will initialize properly and synchronize its mailbox database with that of
the key system.
SYSTEM PROGRAMMING
Review and perform the following programming steps 1 through 7. It is necessary to
perform these at this time so that the SVMi-20E will read these MMCs and initialize
accordingly.
NOTE: Before moving forward if you want to change any of the SVMi-20E default
Extension and Mailbox settings it is best to edit your Extension and Mailbox Templates
now before initializing the SVMi-20E.
3.48
Table of Contents
Home Page
INSTALLATION
PART 3 JUNE 2006