Samsung OfficeServ 7400 Technical Manual page 3

Table of Contents
Home Page
OfficeServ 7400 INSTALLATION
TECHNICAL MANUAL TABLE OF CONTENTS MAY 2006
FIGURE 3.4: Switch Settings
FIGURE 3.5: Installing the Processor Board (1)
FIGURE 3.6: Installing the Processor Board (2)
FIGURE 3.7: LP40 Link Cable
FIGURE 3.8: Connecting the MP40 Board to LP40 Board
FIGURE 3.9: Connecting MP40 to OS7200 LCP
FIGURE 3.10: Front View of the MP40
FIGURE 3.11: Front View of the LP40
FIGURE 3.12: Installing Optional Daughter Cards on the LP40
FIGURE 3.13: Installing Optional Modem Daughter Card on the MP40
FIGURE 3.14: Installing Interface Board into Slot
FIGURE 3.15: Front Panel Lever
FIGURE 3.16: Setting Switches and Jumpers on the TEPRI Board
FIGURE 3.17: Settings Switches and Jumpers on the TEPRIa Board
FIGURE 3.18: Front View of the TEPRI Card
FIGURE 3.19: Front View of the TEPRIa Card
FIGURE 3.20: Setting Switches and Jumpers on the TEPRI2 Card
FIGURE 3.21: Front View of the TEPRI2 Card
FIGURE 3.22: Front View of the 8TRK Card
FIGURE 3.23: Front View of the 16DLI2 Card
FIGURE 3.24: Front View of the 8DLI Card
FIGURE 3.25: Front View of the 8COMBO Card
FIGURE 3.26: Front View of the 16SLI2 Card
FIGURE 3.27: Front View of the 8SLI Card
FIGURE 3.28: Setting GWIM Module Jumpers
FIGURE 3.29: Mounting an Optional Securing Daughter Card on the GWIM Module
FIGURE 3.30: Front View of the GWIM Module
FIGURE 3.31: Cable Pin Outs
FIGURE 3.32: GWIM SIO Connector, RJ45 Pin Assignment
FIGURE 3.33: PLIM Jumper Settings