Samsung OfficeServ 7400 Technical Manual page 115

OfficeServ 7400
TECHNICAL MANUAL
Dry contact #1
(For common bell)
Dry contact #2
(Page Relay)
(For external broadcasting)
Dry contact #3
(Page Relay)
(For external broadcasting)
• MISC 1 and MISC 2 ports are located on the front panel of the MP40.
WARNING: Do not attempt to connect commercial AC power to these contacts.
1) After connecting a common bell, you must assign it in MMC 601 to a group as a
ring destination by using the code for common bell.
2) After wiring to the contact pair, set contacts for continuous or steady operation.
3) Next, program hunt group to include the common bell.
4) Assign the trunk to ring the hunt group containing the common bell. Common bell
control can be used with station hunt groups, individual stations and universal
answer.
7.2.5 Ring Over Page
When a customer-provided paging system is installed, incoming calls can be assigned
to ring over page. Program the C.O. line or C.O. lines to ring a hunt group. Using MMC
601 assign the DN number of the Page Output (voice) for the MIS board being used as
a member of the group or as the NEXT PORT for the overflow destination. Other
stations may be assigned to the same group to provide ringing to phones and the
paging system at the same time.
FUNCTION # in MMC 724
Figure 7.32 Connecting Common Bell
MIS
CAB1
03 361
7.27
Home Page
INSTALLATION
PART 7 JUNE 2006
MISC 2
MISC 1
DEFAULT
DN
CAB2 CAB3
364 367
Table of Contents