Samsung OfficeServ 7400 Technical Manual page 62

Table of Contents
Home Page
OfficeServ 7400 INSTALLATION
TECHNICAL MANUAL PART 3 JUNE 2006
Figure 3.43 SVMi-20E/HD with no optional boards installed (LEFT)
and SVMi-20E/CF with all components installed (RIGHT)
INSERTING THE CARD
NOTE: Before powering off the KSU, it is recommended that you use MMC 740 and set
MBX Download to 'No'.
The SVMi-20E card can be installed in any universal slot of any cabinet. Only ONE
SVMi-20E can be installed per SYSTEM. Check that the OfficeServ 7000 Series
System's power switch is in the OFF position. Next position the SVMi-20E card in the
grooves of the card guide and gently slide the card in until it makes contact with the
connector. Press gently but firmly on the left and right of the front edge of the card until
the card seats in its connector. Press firmly on the Black Front Panel Lever until it
snaps securely in place. The cabinet can now be turned on.
If the SVMi-20E card is being installed in an existing (not new) system, you will have to
use MMC 806 to pre install the card and MMC 724 to assign extension numbers to
each SVMi-20E port. Use any available numbers. After the SVMi-20E card is installed,
either in a new or existing system, you will have to use MMC 601 and assign all the
SVMi port numbers to the last available station group (Group Number 5049 by default).
3.47