Led Indications; Table 6-7 Cd-Cp00-Us Led Indications - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
SW6-4
RUN (LED1)
System Hardware Manual
Table 6-6 CD-CP00-US Switch 6 Settings (Continued)
Configuration
ON
3.1.4

LED Indications

The LEDs on the CPU indicate the following:
RUN (LED 1) = The CPU is operating (green)
LED 2, and 3 = Alarms (red)
LED 4 = Flash access indication (red)
LED 5 = The USB memory connection status (red)
(LED off when no USB memory installed)
Refer to Program 90-10: System Alarm Setup for details on assigning
alarm LEDs.
Table 6-7 CD-CP00-US LED Indications on page 6-21
of each LED and associated operation and status indications. Refer
to Figure 6-3 CD-CP00-US Blade Layout on page 6-14
location of the LEDs on the CD-CP00-US.

Table 6-7 CD-CP00-US LED Indications

LED Indication
LED2 LED3
Blinking Off
Off Off
Off On
Blinking Blinking
Off On
Off On
Reset Configuration
LED4 LED5
Off Off On Steady When
USB Memory is
Installing
Off Off Blinking
Off Off
Off Access On Steady When
Blink USB Memory is
Installing
On Access On Steady When
Blink USB Memory is
Installing
Off Access On Steady When
Blink USB Memory is
Installing
Note
ON = Normal
OFF = ICE Mode
Status
System operating normally
Boot is starting
Off Initializing the disk or
formatting
Boot program is initializing in
the flash memory
Reading system software
Upgrading system software
Issue 1.0
provides a list
for the
6 - 21