UNIVERGE SV8100/SV8300
System Hardware Manual
1.
Remove the screw from the front of the PGD(2)-U10 ADP.
Figure 11-2 Remove Cover from PGD(2)-U10 ADP
2.
Using a screwdriver, break out the plastic piece covering the cable hole.
Figure 11-3 Remove Plastic Cover from Cable Hole
3.
Set the S3 – S6 jumpers to the proper settings for the function to be used
(refer to
Table 11-2 PGD(2)-U10 ADP S3 – S6 Jumper Settings on page
11-4).
Issue 1.0
11 - 3