Table 6-48 Cd-4Diopa Rj-61 Cable Connector Pin-Outs - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
LED Indication
Live LED Busy LED
(Green) (Red)
On
Off
Off
Flash (100ms
On/Off)
System Hardware Manual
Table 6-47 CD-4DIOPA LED Indications (Continued)
Operation Status
A Channel is busy (use
Unit Busy
another from CH1 ~ CHx).
All channels are idle.
Downloading firmware.
5.5.4 Connectors
The CN2 connector provides connection to four analog DID trunk
ports, which are polarity sensitive (tip-to-tip, ring-to-ring). The
OPX circuits, however, are not polarity sensitive. The DIOPU
requires one universal slot. (Refer to
on page 6-85.) If Program 10-03-01 has OPX defined, note that the
blade consumes four (4DIOPU) trunks or eight (8DIOPU) trunks and
extension ports when installed. If OPX is not defined, then only
trunks ports are consumed.
Table 6-48 CD-4DIOPA RJ-61 Cable Connector Pin-Outs on page
6-87 shows the pin-outs for the RJ-61 connector. Refer to
6-27 CD-4DIOPA Blade on page 6-85
location of the connectors on the 4DOIPU blade.

Table 6-48 CD-4DIOPA RJ-61 Cable Connector Pin-Outs

–
–
–
Figure 6-27 CD-4DIOPA Blade
for an illustration showing the
RJ-61 Cable Connector – CN2
Line No. Pin No.
1 5
4
2 3
6
3 2
7
4 1
8
Issue 1.0
Remarks
Figure
Connection
Tip
Ring
Tip
Ring
Tip
Ring
Tip
Ring
6 - 87