Table 5-2 Pz-Bs10/Pz-Bs11 Connector Pin-Out - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
The PZ-BS10 connects the Controlling Chassis to the Expansion
Chassis by connecting to a PZ-BS11, which is installed on each
Expansion Chassis. These Expansion Interface Units allow the CPU
to transmit/receive data as required to the additional chassis.
The PZ-BS10 is installed in the BUS slot of the Controlling Chassis.
The PZ-BS11 is installed in the expansion slot of the Expansion
Chassis.
The BUS cable is used to connect the Controlling Chassis and its
PZ-BS10 to the second, third, and fourth PZ-BS11 interface.
Use only the CAT 5 cables provided by NEC to make the
connections between the Controlling and Expansion Chassis.
The PZ-BS10 provides:
Communication Processor Interface for data handling through
Communication Channel (18 slots maximum)
32 Channels for Telephony Resource (e.g., DTMF Tone Receiver, Call
Progress Tone Detector, Caller ID Receiver, Caller ID Signal Sender)
DSP Resource Management
3.5.5.1 Connector Pin-Out on the PZ-BS10/PZ-BS11

Table 5-2 PZ-BS10/PZ-BS11 Connector Pin-Out

PZ-BS10 – CN2, CN3, CN 4
RJ-61 Cable Connector
PZ-BS11 – CN3
Pin No.
1
2
3
4
5
6
7
8
Issue 1.0
Connection
HW_UP (+)
HW_UP (-)
HW_DWN (+)
FS (+)
FS (-)
HW_DWN (-)
CK8M (+)
CK8M (-)
5 - 37