Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1
Installing the Dump Handle
Parts needed for this procedure:
1
Dump handle
2
Bolt
2
Nut
Installing the Dump Handle to the Drum
1. Cut the cable ties to remove the dump handle from
the underside of the grate.
2. Position the dump handle so that the bolt holes align
with the bolt holes in the drum
Description
Dump handle
Bolt
Nut
Tow pole kit (sold separately)
Safety chain (sold with optional tow pole
kit)
Connecting link (sold with optional tow
pole kit)
No parts required
(Figure
3).
Qty.
1
2
Install the dump handle.
2
1
Install the tow pole.
1
Install the safety chain.
2
–
Adjusting the mixing paddles.
3. Insert 1 of the carriage bolts into the square bolt hole
and slide the corresponding hole of the drum handle
over it.
(Figure
3).
4. Install a nut onto the bolt, and tighten it.
5. Repeat the previous steps for the remaining carriage
bolt.
7
Use
Figure 3