Operation; Preparing To Tow The Machine - Toro MMX-650E-S 60212C Operator's Manual

Operation

Important: Before operating, remove any debris from
the machine. Ensure that the area is clear of people.

Preparing to Tow the Machine

Important: Ensure that your tow vehicle has towing
capacity for the weight of the machine.
Important: Use a Class 2 or larger receiver.
Note: Ensure that your tow vehicle has the appropriate hitch
to tow the machine; options include a 50 mm (2 inch) ball
hitch or a pintle hitch.
Note: If the machine is equipped with a trailer-light kit,
ensure that the electrical connector of the tow vehicle is
compatible with the electrical connector of the machine. The
machine uses a standard 4-flat plug. If your tow vehicle has a
different type of plug, obtain an adapter from an automotive
parts store.
1. Stop the motor, unplug the machine, and empty the
drum.
2. If the drum has accumulated any water, dump the
drum; refer to Dumping the Drum (page
3, 4, and 5.
3. Using the dump lever, position the drum so that it is in
the mix position (upright) and locked.
4. Close the cowl and secure the cowl latches
Figure 13
5. Extend the axle; refer to
(page 15).
21), steps 1,
(Figure 13).
G019741
Adjusting the Axle Width
Checking the Tires and Wheels
Service Interval: Before each use or daily—Inspect the tires
and wheels.
WARNING
Failure to maintain correct tire pressure may result
in tire failure and loss of control, resulting in
property damage and serious injury or death.
• Check the tire pressure frequently to ensure
proper inflation. If the tires are not inflated to
the correct pressure, they will wear prematurely.
• Inspect the tire condition before towing and
after any operating accident.
The DOT tire information is located on the side
of each tire. This information gives load and speed
ratings. Replacement tires should have the same
or better ratings. For more information go to
http://www.nhtsa.gov/Vehicle+Safety/Tires.
Note: The various machines in this manual have different
weights; refer to Specifications (page 11)
tires on your machine meet or exceed the weight requirements
of your machine.
1. Visually inspect the tires for damage and wear
14 and Figure 15).
1. Example of tire wear caused by underinflation
1. Example of tire wear caused by overinflation
2. Ensure that the tires are inflated to the correct air
pressure. The following Tire Air Pressure table shows
12
to ensure that the
G020836
Figure 14
Figure 15
(Figure