Setup; Installing The Tow Pole; Installing The Tongue - Toro 68004C Operator's Manual

Setup

1

Installing the Tow Pole

Side-Dump Models Only
Parts needed for this procedure:
1 Tow pole kit (sold separately)
Tow Pole Specifications
Purchase the tow pole kit (including fasteners) that
meets your needs from your Authorized Service
Dealer. The machine has the following tow pole
options:
Hitch Type
50 mm (2 inch) ball—stamped
50 mm (2 inch) ball—forged
Pintle
Installing the Tow Pole
1. Remove the bolt and nut from the tow pole
(Figure 4).
1. Tow pole
2. Front post
3. Bolt
2. Slide the tow pole forward and align the hole in
the pole with the hole in the frame fitting
4).
Length
78.7 cm (31 inches) or 127 cm
(50 inches)
78.7 cm (31 inches) or 127 cm
(50 inches)
78.7 cm (31 inches) or 127 cm
(50 inches)
Figure 4
4. Bolt hole
5. Frame fitting
6. Nut
3. Insert the bolt through the holes in the fitting and
the pole
4. Thread the nut onto the bolt and tighten them
until they are tight against the frame fitting
(Figure
Note:
locknut wears with use, replace the nut with a
new Grade 5 or Grade 8 locknut.
2

Installing the Tongue

End-Dump Models Only
Parts needed for this procedure:
1 Tongue
1 Front stabilizer leg
6 Short bolt
1 Long bolt
7 Nut
Procedure
1. Lower the rear stabilizer legs; refer to
the Stabilizer Legs (page
2. Place jack stands under the front frame rail
to prevent the machine from tipping forward
(Figure
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious
injury.
Use jack stands when supporting the
machine.
g019804
(Figure
10
(Figure 4).
4).
If the self-locking nylon insert in the
21).
5).
Lowering