Installing the Divider Plate
1. Guide the divider plate into position against the front
cowl.
Note: Start with the divider plate rotated slightly
counterclockwise, and then rotate it clockwise while
lowering it into position.
Figure 31
Note: Ensure that the divider plate is not backward.
2. Align the bolt holes in the divider plate and the front
cowl.
3. Install each of the 4 bolts, and hand-tighten them to
prevent cross-threading.
4. Tighten the bolts with a wrench until they are secure.
Lubrication
Lubricating the Bearings and
Seals
Service Interval: After each use—Lubricate the trunnions.
Monthly—Lubricate the pillow-block bearings.
Note: The pillow-block bearings are inside the
cowl—remove the divider plate to access them; refer to
Removing the Divider Plate (page
Grease type: Number 2 general-purpose lithium-based
grease.
1. Clean around each grease fitting with a rag and lift the
plastic cap off the grease fitting
G021586
1
1
2
1. Pillow-block bearings
2. Rear trunnion
23
22).
(Figure
32).
2
3
3
Figure 32
3. Front trunnion
g021 101