Toro MMX-650E-S 60212C Operator's Manual page 28

Installing the Belts
1. Ensure that the clutch lever is in the O
refer to Controlling the Paddles (page
2. Align the rear belt to the rear groove in the motor
pulley.
Note: Do not align the rear belt to the idler pulley.
3. Align the forward belt to the forward groove of the
idler pulley.
4. Slip the rear belt over the idler pulley and align the belt
to the rear pulley groove.
5. Slip the forward belt over the motor pulley and align
the belt to the forward pulley groove.
6. Check the belt tension; refer to step 1, step 2, and step
3 in Adjusting the Belt Tension (page
7. Loosely secure the belt guide to the motor
with the bolt that was removed in step
the Belts (page 27).
8. Adjust the belt guide; refer to
(page 28).
9. Install the divider plate; refer to
Plate (page 23).
Adjusting the Belt Guide
Note: To access the belt guide, remove the divider plate;
refer to Removing the Divider Plate (page
Guide air gap: 2.5 to 4.0 mm (3/32 to 5/32 inch)
1. Ensure that the clutch lever is in the O
to Controlling the Paddles (page
2. Ensure that the belt tension is correct; refer to
Adjusting the Belt Tension (page
3. Check that the air gap between the belt guide and the
belts is 2.5 to 4.0 mm (3/32 to 5/32 inch); refer to
Figure 43.
position;
FF
19).
26).
(Figure 41)
3 of Removing
Adjusting the Belt Guide
Installing the Divider
22).
position; refer
N
19).
26).
3
2
1
1. Motor pulleys
2. Belts
3. Guide air gap: 2.5 to 4.0
mm (3/32 to 5/32 inch)
4. If the air gap is not within the specified range, do the
following:
A. Loosen the nut that secures the belt guide to the
motor (Figure
Important: Ensure that the belt guide is
toward the motor pulley.
B. Rotate the belt guide up or down until there is
an air gap of 2.5 to 4.0 mm (3/32 to 5/32 inch)
between the guide and each belt
Important: The belt guide should not
contact the belts with the clutch lever in the
O position.
N
Note: If the air gap between the belt guide and
both belts cannot be attained, then 1 of the belts
is too long.
C. Tighten the nut that secures the belt guide to the
motor (Figure
D. Check the clutch operation; refer to
Clutch Operation (page
5. Install the divider plate; refer to
Plate (page 23).
28
4 5
G020666
Figure 43
4. Belt guide
5. Nut
43).
(Figure
43).
Checking the
29).
Installing the Divider
43).