Lubricating The Drive Chain; Belt Maintenance; Servicing The Belts - Toro MMX-650E-S Operator's Manual

Lubricating the Drive Chain

Service Interval: Every 40 hours—Lubricate the
drive chain with a non-sticky chain
lubricant.
Apply a chain lubricant that is non-sticky to help
prevent dirt and abrasive particles from sticking to the
chain.
Figure 33
1. Drive chain

Belt Maintenance

Servicing the Belts

Inspecting the Belts
Service Interval: After the first 25 hours—Inspect the
Every 40 hours—Inspect the belts and adjust
as necessary.
1. Remove the divider plate; refer to
Divider Plate (page
2. Move the clutch lever to the O
to Controlling the Paddles (page
3. Examine the belts for wear or damage. If the
belts are worn or damaged, replace them; refer
to Replacing the Belts (page
4. Examine the pulleys for wear, damage, and
misalignment; refer to
31).
g021584
5. Install the divider plate; refer to
Divider Plate (page
Adjusting the Belt Tension
Clutch air gap: 2.5 to 6.5 mm (3/32 to 1/4 inch)
1. Move the clutch lever to the O
Controlling the Paddles (page
2. Measure the air gap between the motor deck
and the roller on the clutch
1. Motor deck
2. Clutch roller
28
belts and adjust as necessary.
Removing the
25).
position; refer
FF
21).
29).
Aligning the Pulleys (page
Installing the
26).
position; refer to
N
21).
(Figure
Figure 34
3. Clutch air gap: 2.5 to 6.5
mm (3/32 to 1/4 inch)
34).
g019976