Table of Contents
Advertisement
2
Installing the Tow Pole
Parts needed for this procedure:
1
Tow pole kit (sold separately)
Installing the Tow Pole to the
Machine
Note:
The tow pole is purchased separately and
includes the nut and bolt needed for installation.
The machine has the following tow pole options:
Hitch Type
50 mm (2 inch) ball—stamped
50 mm (2 inch) ball—forged
Pintle
1.
Remove the bolt and nut from the tow pole
(Figure
4).
1. Tow pole
2. Front post
3. Bolt
2.
Slide the tow pole forward and align the hole in
the pole with the hole in the frame fitting
4).
3.
Insert the bolt through the holes in the fitting and
the pole
(Figure
4).
4.
Thread the nut onto the bolt and tighten them
until they are tight against the frame fitting
(Figure
4).
Note:
If the self-locking nylon insert in the
locknut wears with use, replace the nut with a
new Grade 5 or Grade 8 locknut.
Length
78.7 cm (31 inches)
78.7 cm (31 inches)
78.7 cm (31 inches)
Figure 4
4. Bolt hole
5. Frame fitting
6. Nut
3
Installing the Safety Chain
Parts needed for this procedure:
1
Safety chain (sold with optional tow pole kit)
2
Connecting link (sold with optional tow pole kit)
Installing the Safety Chain
Note:
The safety chain is part of the optional tow
pole kit.
1.
Form a hook on the end of a bendable piece
of rod or stiff wire (not included), and insert it
through both keyholes in the front post of the
machine
g019804
1. Keyhole
2. Rod or wire (not included)
2.
Attach the safety chain to the length of rod or
(Figure
wire
(Figure
3.
Pull the rod, or wire, and the safety chain
through both keyholes
Note:
of safety chain extend from either side of the
front post.
9
(Figure
5A).
Figure 5
3. Safety chain
4. Connecting link
5A).
(Figure
Ensure that approximately equal lengths
g019883
5B).
Advertisement
Table of Contents
