Table of Contents
Advertisement
Operation
Important:
Before operating, remove any debris
from the machine. Ensure that the area is clear
of people.
Preparing to Tow the
Machine
Important:
Ensure that your tow vehicle has
towing capacity for the weight of the machine.
Important:
Use a Class 2 or larger receiver.
Note:
Ensure that your tow vehicle has the
appropriate hitch to tow the machine; options include
a 50 mm (2 inch) ball hitch or a pintle hitch.
Note:
If the machine is equipped with a trailer-light
kit, ensure that the electrical connector of the tow
vehicle is compatible with the electrical connector of
the machine. The machine uses a standard 4-flat
plug. If your tow vehicle has a different type of plug,
obtain an adapter from an automotive parts store.
1.
Stop the motor, unplug the machine, and empty
the drum.
2.
If the drum has accumulated any water, dump
the drum; refer to
steps 1, 3, 4, and 5.
3.
Using the dump lever, position the drum so that
it is in the mix position (upright) and locked.
4.
Close the cowl and secure the cowl latches
(Figure
13).
Figure 13
5.
Extend the axle; refer to
(page
17).
Dumping the Drum (page
Extending the Axle
Checking the Tires and Wheels
Service Interval: Before each use or daily—Inspect
WARNING
Failure to maintain correct tire pressure
may result in tire failure and loss of control,
resulting in property damage and serious
injury or death.
• Check the tire pressure frequently to
ensure proper inflation. If the tires are not
inflated to the correct pressure, they will
wear prematurely.
• Inspect the tire condition before towing
and after any operating accident.
The DOT tire information is located on the side of
each tire. This information gives load and speed
ratings. Replacement tires should have the same
or better ratings. For more information go to
http://www.nhtsa.gov/Vehicle+Safety/Tires.
Note:
The various machines in this manual have
different weights; refer to
ensure that the tires on your machine meet or exceed
the weight requirements of your machine.
24),
1.
Visually inspect the tires for damage and wear
(Figure 14
1. Example of tire wear caused by underinflation
g019741
1. Example of tire wear caused by overinflation
14
the tires and wheels.
Specifications (page 12)
and
Figure
15).
Figure 14
Figure 15
to
g020836
g010293
Advertisement
Table of Contents
