Table of Contents
Advertisement
3.
Remove the nut that secures the belt guide to
the motor, and remove the belt guide
37).
1. Nut
4.
Slip the forward belt forward and off the idler
pulley
(Figure
38).
1. Motor pulley
2. Forward belt
5.
Slip the rear belt rearward and off the idler pulley
(Figure
38).
6.
Slip the belts off the motor pulley.
7.
Remove the belts from the machine.
Installing the Belts
1.
Ensure that the clutch lever is in the O
position; refer to
21).
2.
Align the rear belt to the rear groove in the motor
pulley.
(Figure
Figure 37
2. Belt guide
Figure 38
3. Idler pulley
4. Rear belt
Controlling the Paddles (page
Note:
pulley.
3.
Align the forward belt to the forward groove of
the idler pulley.
4.
Slip the rear belt over the idler pulley and align
the belt to the rear pulley groove.
5.
Slip the forward belt over the motor pulley and
align the belt to the forward pulley groove.
6.
Check the belt tension; refer to step 1, step 2,
and step
28).
7.
Loosely secure the belt guide to the motor
(Figure
step
8.
Adjust the belt guide; refer to
g021601
Guide (page
9.
Install the divider plate; refer to
Divider Plate (page
Adjusting the Belt Guide
Note:
To access the belt guide, remove the divider
plate; refer to
Guide air gap: 2.5 to 4.0 mm (3/32 to 5/32 inch)
1.
Ensure that the clutch lever is in the O
refer to
2.
Ensure that the belt tension is correct; refer to
Adjusting the Belt Tension (page
3.
Check that the air gap between the belt guide
and the belts is 2.5 to 4.0 mm (3/32 to 5/32
inch); refer to
g021608
FF
1. Motor pulleys
2. Belts
3. Guide air gap: 2.5 to 4.0
mm (3/32 to 5/32 inch)
30
Do not align the rear belt to the idler
3
in
Adjusting the Belt Tension (page
37) with the bolt that was removed in
3
of
Removing the Belts (page
30).
26).
Removing the Divider Plate (page
Controlling the Paddles (page
Figure
39.
Figure 39
4. Belt guide
5. Nut
29).
Adjusting the Belt
Installing the
25).
position;
N
21).
28).
g020666
Advertisement
Table of Contents
